Water Damage Restoration Cost in Hurst, TX
Use the estimator to get a rough range for a water damage job in Hurst, based on the size of the wet area, the type of water and the materials involved. Every figure is a range, and the crew sets the actual price after an on-site inspection. General market ranges, not quotes.
Water Damage Cost Estimator for Hurst
Move the slider to the size of the wet area, pick the type of water and tick what applies. The range uses general market rates: clean water removal and drying at about $3 to $7.50 per sq ft, sewage at about $7 to $14 per sq ft.
General market ranges, not quotes. The crew sets the real price after an on-site inspection.
Call (817) 555-0152 for a real priceWhat Affects the Cost of Water Damage Restoration in Hurst
- Wet area size. Extraction, drying and tear-out are usually priced by the square foot, so a wet hallway costs far less than a soaked living room, dining room and kitchen. Estimate the wet area before you call.
- Water category. Clean water from a supply line costs the least to handle. Gray water from a washer or dishwasher, and category 3 water from a sewer backup or outside runoff, need more removal, cleaning and protective gear.
- How long it sat. Water caught within hours can often be dried in place. Water that sat for days has wicked higher into drywall, soaked the pad and may have turned from clean to contaminated.
- Materials. Carpet can often be dried in place, though the pad usually gets replaced. Hardwood needs slow mat drying or replacement, and wet drywall is often flood cut a little above the wet line.
- Rooms and floors. Each wet room adds equipment. An attic leak that soaks insulation and a ceiling, or an upstairs unit that leaks into the one below, adds a second area to dry.
- Hidden water. Water inside walls, under cabinets or under flooring on the slab takes leak detection, moisture mapping and sometimes opening walls, which adds labor and equipment days.
- Access and contents. Attic work, tight closets and rooms packed with furniture take longer to reach and protect. Packing out and cleaning contents is usually priced on its own.
Typical Price Ranges in Hurst
| Situation | Typical range |
|---|---|
| Water removal and drying, clean water | $3 to $7.50 per sq ft |
| Small clean-water cleanup (one room) | $1,200 to $4,000 |
| Burst pipe or water heater cleanup with drying | $1,500 to $6,500 |
| Leak detection visit | $150 to $500 |
| Ceiling repair after a leak | $400 to $2,000 |
| Roof leak emergency tarp | $250 to $1,000 |
| Sewage (category 3) cleanup, typical job | $2,500 to $12,000 |
General market ranges, not quotes.
Water damage pricing in Hurst usually comes in stages. Mitigation is the emergency work: extraction, removing wet pad or baseboards, and running drying equipment. Equipment is often billed per unit per day, about $60 to $150 for each dehumidifier and $25 to $50 for each air mover, so a job that needs five drying days costs more than one that dries in three. Tear-out, such as flooring removal at $1 to $3 per sq ft, is listed on its own line. Rebuild work, like drywall at $2 to $6 per sq ft or ceiling repair between $400 and $2,000, is usually estimated once the structure is dry. General market ranges, not quotes.
When you compare scopes, line them up item by item. Check the square footage each provider measured, how many dehumidifiers and air movers they plan to run and for how many days, what will be removed and what will be dried in place, and whether rebuild is included or estimated later. In older Hurst homes, ask whether the scope covers moisture checks inside walls and under cabinets, where slow leaks often hide. A lower total that skips readings or leaves wet pad in place can cost more once swelling or odor appears. Ask for daily moisture readings in writing.
Water Damage Cost FAQs
How much does it cost to dry one wet room?
A small clean-water cleanup in one room usually runs $1,200 to $4,000, depending on the flooring and how far water wicked into the walls. General market ranges, not quotes.
What does a garage or closet water heater leak cost to clean up?
A burst pipe or water heater cleanup with drying often falls between $1,500 and $6,500. If base cabinets swell, repair or replacement can add $1,500 to $6,000. General market ranges, not quotes.
How much does slab leak detection cost?
A leak detection visit typically runs $150 to $500, and a thermal imaging or moisture inspection $200 to $600. Drying and floor repairs after the plumber fixes the line are priced separately. General market ranges, not quotes.
Why does sewage cleanup cost more?
Category 3 water means removing porous materials, disinfecting and working in protective gear, so cleanup runs about $7 to $14 per sq ft, with typical jobs between $2,500 and $12,000. General market ranges, not quotes.
What does a hail roof leak cost inside the house?
An emergency roof tarp usually runs $250 to $1,000, and interior mitigation after a roof leak $1,000 to $5,000, before ceiling and insulation repairs. General market ranges, not quotes.
Want a Real Number? Call Now.
A local crew can inspect, measure moisture and give you a written scope and price.